The working principle of three type pneumatic ball valve

3 type pneumatic ball valve's principle of work is as follows: a, open process


in the closed position, sphere subjected to mechanical pressure pneumatic valve stem, press on the pneumatic valve seat.
when counterclockwise rotation handwheel, pneumatic valve stem is reverse movement, the Angle at the bottom of the plane made a sphere release pneumatic valve seat.
pneumatic valve stem continue to ascend, and pneumatic valve rod guide pin of interaction in the spiral groove, the sphere began to rotate without some friction.
until to the fully open position, pneumatic valve stem ascending to limit position, sphere rotation to the full open position.


2, close the process
is closed, the handwheel clockwise, pneumatic stem began to drop and the ball left pneumatic seat begin to spin.
to rotate handwheel, pneumatic valve stem is embedded in the spiral groove on the role of the guide pin, pneumatic stem and ball ° rotating at the same time.
almost closed, sphere has been in contact with the pneumatic valve seat without rotating under the condition of the °.
the hand wheel rotation of the last few laps, pneumatic valve stem mechanically wedge Angle at the bottom of the plane to the oppression of a sphere, make its strong pressure on the pneumatic valve seat, completely sealed.


this address: http://www. hgvalve。 com/tech/qf/。 HTML
pneumatic brake valve pneumatic valve by pneumatic ball valve pneumatic control valve hydraulic pneumatic valve pneumatic valve check pneumatic butterfly valve pneumatic valves regulate the pneumatic valve cock hydrophobic filter pneumatic valve and pressure relief valve