The use of pulse pneumatic valve in the filter

pulse pneumatic valve is pulse blowing ash removal device of institutions and key components of the street, the main points, right Angle type, submerged type and straight through three categories, it is worth noting that the domestic pulse pneumatic valve working pressure; Rectangular pneumatic valve for pneumatic valve and direct. - 。 MPa； No matter which kind of pneumatic valve, imported products are pressure range. - 。 MPa, two types of pneumatic valve is not under pressure and the application of high and low pressure difference.
rectangular pulse pneumatic valve structure and working principle. Rectangular pulse pneumatic valve is characterized by the pneumatic valve air import and export tube degree angles. Pneumatic valve of the pulse pneumatic diaphragm valve is divided into before and after two air chamber, when turn on the compressed air, compressed air after orifice into the chamber, and the gas chamber pressure at this time the diaphragm to pneumatic valve, the output pulse pneumatic valve in the 'off' state. Pulse control instrument electrical signal to make electromagnetic pulse pneumatic valve armature move, after pneumatic valve, open vent gas chamber, air chamber after vocal cord pressure loss, diaphragm backward-shift, compressed air blowing, pneumatic valve can output pulse pneumatic valve in a state of 'open'. Instant compressed air from the pneumatic valve inside, blowing air. TMF - Z( DMF - Z cartesian type electromagnetic pulse pneumatic valve technical parameters are as follows: to adapt to the environment: - temperature ℃; Relative humidity is no more than %.
working medium: clean air, and dew point ℃. Blowing air pressure:. - - - - - - 。 MPa。 Electromagnetic pilot work voltage and current of pneumatic valve: DCV,. 一个; ACV，. 一个; ACV，. A pulse pneumatic valve inlet songs in package, the outlet after spray torch. Between the connection, the thread should be tetrafluoroethylene ribbons, to ensure the seal. Connection to note that the inlet end of modern thread into the thread length is not greater than even the wire a third place.
submerged pulse pneumatic valve structure principle. Submerged pulse pneumatic valve with submerged in the installation method of gas bag, therefore calls flooded type. It compared with other forms of structure, to reduce the flow resistance, reduce the air pressure is blowing, and can apply to depress occasions, and can reduce energy consumption and extend the life of the diaphragm.
TMF - Y( DMF - Y submerged electromagnetic pulse pneumatic valve and the rectangular pulse pneumatic valve technology parameters is different: : blowing air pressure. - 。 MPa, can also be used. - 。 MPa cut-through pulse pneumatic valve. Straight through the structure characteristic of pulse pneumatic valve is the center line of the air import and export on a straight line, therefore calls the pass-through pneumatic valve, the pulse pneumatic diaphragm valve divides into the pulse pneumatic valve before and after the two air chamber, turn on the compressed air when the pulse pneumatic valve closed, open the action principle and rectangular pneumatic valve is the same, just at the time of air jet flow in a different direction. Straight through the pulse pneumatic valve is the advantages of convenient installation, commonly used air box pulse dust collector; Defect is bigger air flow through the pneumatic valve body resistance. TMF - T( DMF - T straight through electromagnetic pulse pneumatic valve and the rectangular pulse pneumatic valve technology parameters are the same.