The main characteristic of pneumatic butterfly pneumatic valve to the clamp

electric single-seat regulating pneumatic valve control all kinds of high temperature and low temperature high pressure fluid, is a kind of the adjustment of the pressure balance type pneumatic valve, good dynamic stability, low noise, small cavitation corrosion. In use at the scene, many are often not because of quality caused by adjusting the pneumatic valve itself, but rather to adjust the installation that caused by improper use of pneumatic valve, such as installation environment, installation position and direction due to reasons such as caused by improper or line is not clean. Therefore electric single-seat regulating pneumatic valve in the installation should pay attention to the following aspects: when using, electric single-seat regulating pneumatic valve installed before deal with pipeline cleaning, eliminate dirt and welding slag. After installation, to ensure that no residue in pneumatic valve body, should also again for pneumatic valve and clean, the access into the medium should make all pneumatic valve opens, so as to avoid impurities get stuck. After using the handwheel institutions, should be restored to the original neutral position. , install electric single-seat regulating pneumatic valve pipe generally do not too high above the ground or floor, should try to set up a platform when pipe height is greater than m, facilitate the handwheel operation and easy maintenance. And regulating pneumatic valve should be installed vertically, commonly special circumstances can tilt, such as large tilt Angle or pneumatic valve itself when the weight is too big to pneumatic valve should increase support protection. , electric single-seat regulating pneumatic valve belongs to the field instruments, environmental temperature should be - ~ ℃ scope, relative humidity % or less. If it is installed in the open air or high temperature applications, waterproof, cooling measures should be taken. Where there is the source to stay away from source or increase the antivibration measures. , in order to make the electric single-seat regulating pneumatic valve in case of failure or repair can continue to make the production process, adjust the pneumatic valve should add by-pass line. At the same time also should pay special attention to, to adjust the installation position of pneumatic valve whether accord with the requirement of technological process. And actuator reducer lubrication, should be paid attention to after repairing and low speed motor generally don't cheer unpick and wash. Pneumatic valve position after assembly should also check whether conform with pneumatic valve opening instructions. , electric single-seat regulating electric part of the pneumatic valve installation shall be in accordance with the relevant requirements for electrical equipment construction. So flameproof products should be according to the explosive dangerous location electrical equipment installation specification requirements for installation. Such as the scene copper-clad SBH type or other for six or eight core, diameter. Mm rubber cable installation. In the use of maintenance, in the explosive place the flame-proof surface electricity open repair and shall be strictly forbidden to pry. At the same time in dismantling the harm upon or scratch flame-proof surface, after repair to be reverted to the original state of flame-proof requirement.
YAZE( Pneumatic company's main products: pneumatic pneumatic valve pneumatic ball valve pneumatic butterfly valve pneumatic actuator