The four important matters cylinder working environment

Cylinder is the entire pneumatic actuators in the system, the compressed air into mechanical energy output, is the important guarantee of the operation of the pneumatic components, then its working environment and what are the essential points of the need to pay attention to? The brief analysis of zhongyuan pneumatic components for everybody below: the cylinder before the use should check whether there is any loose on the installation points and manipulation should consider safety interlock. Sequential control, should check cylinder each working position. 。 Dustproof cylinder in a dusty environment when using, should set the dust cover on the piston rod. Single-acting cylinder breathing hole to install the filter, to prevent the inhalation of dust from breathing hole. 。 To need oil mist lubrication device for the oil cylinder, choose to use the oil deal with sealing ring does not produce expansion, contraction, and does not produce emulsion with moisture in the air. 。 Control of cylinder connected to the pipe before have to purge the lines of dirt, prevent the cylinder from the ingress of debris. 。 The environment temperature is usually stipulated the working temperature of cylinder ~ ℃. Cylinder under ℃ situations, sometimes because of the water contained in the compressed air condenses bring adverse effect on a cylinder. At this point, the requirement of compressed air dew point temperature below ambient temperature ℃; Prevent compression condensation of water vapour in the air. At the same time to consider lubrication and seal type used in low temperature.