Pneumatic valve blockage prevention methods

Pneumatic valve physical wiring diagram _ _1 pneumatic valve figure number. Cleaning, pipeline welding slag, rust, pulp are under the throttle mouth, guiding parts, valve cover balance hole blockage or stuck valve core surface, guide surface strain and scratches, seal surface indentation, etc. This often happens in the early new operation system and put into operation after overhaul. This is a common fault. 2. External flushing method, for some easy to precipitate, medium containing solid particles using ordinary valve adjustment, often at the throttle mouth jam, guide, can the cover bottom plug in an external erosion gas and steam. When the valve is blocked or jammed, open an external gas or steam valve, can be completed in under the condition of fixed regulator flush work, make the normal operation of valve. 3. Installation of pipeline filter method, the small diameter of the regulator, especially ultra-small flow regulating valve, the throttling clearance, small, medium can't have a little residue. Encounter this jam, installation of a strainer before valve line, to ensure that the media to go through. Take use of regulating valve locator, locator is not normal work, the pneumatic throttle mouth jam is a common fault. With locator at work, therefore, must deal with gas source, usually adopts the way is in front of the locator air pipeline air filtering pressure reducing valve installed on 4. Increase the throttle gap method, such as solid particles in the medium or washed off in pipe welding slag and rust due to pass the throttle mouth such as jam, jam, such as fault, can convert the throttle gap bigger throttle piece - Throttling area of a window, open the valve core and the sleeve, rather than the circumference of a circle because of the throttling area of concentration distribution, fault can easily be ruled out. If you are single, two-seat valves can change the plunger valve core form to 'V' shape of valve core, or into a sleeve valve, etc. Such as a chemical plant has a two-seat valves often gets stuck, recommend to switch to the sleeve valve, problem be solved immediately. 5. Dielectric flushing method, using the medium their energy flushing, flushing and take things easy to precipitate, easy to jam, thus improve the function of valve stem. Common methods include: (1) flow into closed type use; (2) adopts streamlined body; (3) puts throttling mouth wash, a lot of adopted should pay attention to improve the throttling parts material erosion resistant ability. 6. Direct to the Angle, through to pour S flow, flow complex, upper and lower chamber should dead zone, provides the medium of precipitation. Angle connection, flows through 90 ℃ medium like elbow, washing performance is good, dead zone is small, easy, designed to streamline. Therefore, using the pass-through regulator slight jams can be used to Angle valve.