Jinan cylinder custom standardization process

Jinan undertake the production of non-standard pieces of miniature cylinder cylinder customization, mature production technology, advanced equipment, high quality and low price. Can according to the buyer to provide technical parameters, such as diameter, stroke as well as provide the high quality level of custom service. Products meet the national minimum standards and industry standards. Fast delivery, perfect after-sales service and on-site installation. Regular on-site maintenance, maintenance. Jinan cylinder introduce non-standard pieces of custom installation method: mini cylinder according to the host need to customize. Such as range, determine the cylinder bore, stroke, speed, to choose the right cylinder model. First, make sure the cylinder bore. According to the size of the work force needed for, considering the cylinder loading rate of thrust and tension in the piston rod. Because of its less pressure (cylinder 。 ~。 MPa） Not so, the output force, generally in the N ( No more than N) Or so, the output power is too large volume ( Diameter) It will be too big, so should try to use force on pneumatic equipment, in order to reduce the size of the cylinder. The second is to determine the cylinder stroke. Cylinder ( The piston) Stroke and its using situation and work institution than the itinerary. In most cases should not be used with stroke, in order to avoid the piston and cylinder head collide, especially used for clamping etc, in order to ensure the clamping effect, must according to calculate the travel allowance trip ~ mm more. Is the rate of movement of the cylinder again. Cylinder driven mainly by the movement speed of job agencies need to decide. Require speed is slow, steady, appropriate USES gas-liquid damping cylinder or use the throttle control. Throttling control ways are: horizontal thrust load is recommended with exhaust throttling; Vertical installation recommended intake throttle lifting load; See basic loop circuit section. Use can make the cylinder cushion cylinder impact phenomenon does not occur in the terminal, usually buffer cylinder in a resistance load and speed is not high, the buffer effect is obvious. If the speed is high, the terminal tend to impact.