Hydrophobic pneumatic valve installation points of steam

） , before cleaning tube equipment, remove impurities, so as to avoid blockage.
) Pneumatic valve, steam trap must be installed under low steam equipment and drainage, easy maintenance, and centralized arrangement as far as possible, in order to facilitate management, connection should be firmly connected.
) , installation, pay attention to the pneumatic direction arrow on the valve body and piping within the medium flow direction should be consistent.
) , for without the filter of pneumatic valve, steam trap shall be installed in front of the pneumatic valve filter, the flow area shall not be less than the channel area. Times, the location of the filter should be set in the easy to tear open outfit.
) And where there is a possibility that a freeze, antifreezing measures should be taken.
) Pneumatic valve, steam trap installation is completed, need to hydrostatic test, testing pressure is the same as the piping system's test pressure.
) , installation practices requirements see national architectural design standard atlas R of the steam condensate recovery and hydrophobic device selection and installation of sample and the manufacturer.