Hydrophobic pneumatic valve installation method, improve production efficiency

right hydrophobic pneumatic valve installation method: hydrophobic pneumatic valve installation is appropriate, to the normal work of the hydrophobic pneumatic valve and equipment production efficiency has a direct impact. Installation of hydrophobic pneumatic valve must be installed according to the formal requirements, to make hydrophobic pneumatic valve and equipment to achieve the best working efficiency. , before installing the hydrophobic pneumatic valve must be used with pressurized steam purging pipes, clear away the clutter in the pipeline. , hydrophobic pneumatic valve should be installed before the filter, ensure that hydrophobic pneumatic valve from the piping sundry jam, regular cleaning filter. , hydrophobic before and after pneumatic valve pneumatic valve installation, convenient hydrophobic pneumatic valve to pick up at any time. , the condensate flow to consistent with hydrophobic pneumatic valve installation arrow mark. And hydrophobic pneumatic valve should be installed at the lowest equipment export, discharge frozen water in time, avoid tube produce steam resistance. No where, if the minimum hydrophobic pneumatic valve installation, should add a departure is curved in the lowest outlet locations ( Water lifting sub, the condensation water again after improve hydrophobic pneumatic valve, lest produce steam resistance. And hydrophobic pneumatic valve outlet pipe should not be submerged in the water. ( If it is immersed in water, should drill a hole in the curved, destroying the vacuum, prevent sand back to the suction. Hydrophobic, mechanical type pneumatic valve to horizontal position. Pneumatic valve, steam trap do not install in series. , each device should be installed each hydrophobic pneumatic valve. Before, hot static type of trap pneumatic valve need to have more than one meter is not too cold tube of the heat preservation, other form hydrophobic pneumatic valve should be close to the equipment. , drum drying ( With siphon type hydrophobic pneumatic valve is used in the equipment please indicate: choose the hydrophobic pneumatic valve with the steam resistance device rotor pump, avoid steam locking device. , hydrophobic after pneumatic valve such as the condensate recovery, hydrophobic pneumatic valve outlet pipe should be recycling manager on top of the main access, reduce the back pressure, prevent backflow. , hydrophobic if there are any condensate recovery after pneumatic valve, different pressure levels of pipeline to separate recycling. And hydrophobic pneumatic valve can't climb, after the condensate recovery manager will increase the back pressure of hydrophobic pneumatic valve. , hydrophobic pneumatic valve after water before entering the recycling manager to install check pneumatic valve, prevent condensate return. Pneumatic valve, steam pipeline in scanty water, the main line to set up a close to the main line radius of condensate ShuiJi Wells, and then with a small tube to drain the pneumatic valve. Hydrophobic, mechanical type pneumatic valve without for a long time, to remove drain screw put the water inside, to prevent freezing. , found that hydrophobic pneumatic valve, steam, to timely drainage and clean screen pack, according to the practical use, frequently check in case of failure repair at any time. To access at least once a year to remove impurities. Hydrophobic pneumatic valve in the steam system is considered to be a small parts, but a great influence on system and economic operation, so the maintenance and overhaul of hydrophobic pneumatic valve is also vital, hydrophobic pneumatic valve only full attention to the important role in the production. Regular maintenance, make hydrophobic pneumatic valve is always in good working condition, can guarantee the best energy saving effect and improve the economic benefit.