Hydrophobic pneumatic valve installation guide

hydrophobic pneumatic valve installation is appropriate, to the normal work of the hydrophobic pneumatic valve and equipment production efficiency has a direct impact.
installation hydrophobic pneumatic valve must be installed according to the formal requirements, can we make hydrophobic pneumatic valve and equipment to achieve the best working efficiency.
。 Before installing the hydrophobic pneumatic valve must be used with pressurized steam purging pipes, clear away the clutter in the pipeline.
。 Hydrophobic pneumatic valve should be installed before the filter, ensure that hydrophobic pneumatic valve from the piping sundry jam, regular cleaning filter.
。 Hydrophobic before and after pneumatic valve pneumatic valve installation, convenient hydrophobic pneumatic valve to pick up at any time.
。 The condensate flow to consistent with hydrophobic pneumatic valve installation arrow mark.
。 Hydrophobic pneumatic valve should be installed at the lowest equipment export, discharge frozen water in time, avoid tube produce steam resistance.
。 If there is no location equipment at the lowest hydrophobic pneumatic valve installation, should add a departure is curved in the lowest outlet locations ( The condensate increased joint) , the condensation water again after improve hydrophobic pneumatic valve, lest produce steam resistance.
。 Hydrophobic pneumatic valve outlet pipe should not be submerged in the water. （ If it is immersed in water, should drill a hole in the curved, destroying the vacuum, prevent sand back to the suction. ）
。 Mechanical type hydrophobic pneumatic valve to install.
。 Pneumatic valve steam traps do not install in series.
。 Each device should be installed each hydrophobic pneumatic valve.
。 Before the hot static type of trap pneumatic valve need to have more than one meter is not too cold tube of the heat preservation, other form hydrophobic pneumatic valve should be close to the equipment.
。 Drum drying ( With siphon type) Hydrophobic pneumatic valve is used in the equipment please indicate: choose the hydrophobic pneumatic valve with the steam resistance device, avoid steam locking device.
。 Hydrophobic after pneumatic valve such as the condensate recovery, hydrophobic pneumatic valve outlet pipe should be recycling manager on top of the main access, reduce the back pressure, prevent backflow.
。 If you have the condensate recovery after hydrophobic pneumatic valve, different pressure levels of pipeline to separate recycling.
。 Drain the condensate recovery after pneumatic valve manifold can't climb, will increase the back pressure of hydrophobic pneumatic valve.
。 Hydrophobic pneumatic valve after water before entering the recycling manager to install check pneumatic valve, prevent condensate return.
。 In steam pipe jacket hydrophobic pneumatic valve, main line to set up a close to the main line radius of condensate ShuiJi Wells, and then with a small tube to drain the pneumatic valve.
。 Mechanical type hydrophobic pneumatic valve without for a long time, to remove the drain screw inside the water drop, to prevent freezing.
。 Found that the hydrophobic pneumatic valve steam, to timely drainage and clean screen pack, according to the practical use, frequently check in case of failure repair at any time. To access at least once a year to remove the
the impurities.
hydrophobic pneumatic valve in the steam system is considered to be a small parts, but a great influence on system and economic operation, so the maintenance and overhaul of hydrophobic pneumatic valve is also vital, hydrophobic pneumatic valve only full attention to the important role in the production. Regular maintenance, make hydrophobic pneumatic valve is always in good working condition, can guarantee the best energy saving effect and improve the economic benefit.