How to install heavy cylinder?

According to the installation of heavy cylinder form, can be divided into detachable and stationary cylinder. According to the installation forms can be divided into stationary and oscillating cylinder, embedded, four kinds of rotary cylinder. Heavy cylinder before the installation, should by the no-load test run and in. Pressure testing times the maximum operating pressure, operating normally and can be used only no leakage phenomenon, and the heavy cylinder connected to the pipe before must clean the dirt in the pipe, prevent debris into the cylinder, load in the travel have change, should use output force abundant cylinder, and the additional buffer device. Buffer cylinder before starting to run, the buffer throttle twist in the first section flow smaller bits, then gradually up, until transferred to the satisfaction of the buffer effect. Not use happy trip, especially when the piston rod out, don't make the piston rod into the cylinder head, otherwise, easy to cause the piston rod and the external load of concentration. Heavy cylinder installation form should be used according to the installation position, objective factors such as the decision. In the general case, USES the fixed cylinder, when the need to work with agencies continuous rotary ( Such as the lathe, grinding machine, etc. ) , should choose the rotary cylinder, have special requirements, should choose the corresponding special cylinder.