How to install cylinder?

According to the installation of the cylinder form, can be divided into detachable and stationary cylinder. According to the installation forms can be divided into stationary and oscillating cylinder, embedded, four kinds of rotary cylinder. , cylinder before the installation, should by the no-load test run and in. Pressure testing times the maximum operating pressure, operating normally and no leakage phenomenon rear can use. Pipeline, cylinder connected to the pipe before, it is necessary to remove dirt, prevent the cylinder from the ingress of debris. , load in the travel have change, should use abundant cylinder, output force and additional buffer device. , buffer cylinder before starting to run, the buffer throttle twist in the first section flow smaller location, then gradually up, until transferred to the satisfaction of the buffer effect. And not use happy trip, especially when the piston rod out, don't make the piston rod into the cylinder head. Otherwise, easy to cause the piston rod and external load of concentration. , cylinder installation form should be used according to the installation position, objective factors such as the decision. In the general case, using the fixed type cylinder. When need to work with agencies continuous rotary ( Such as the lathe, grinding machine, etc. ) , should choose the rotary cylinder. When have special requirements, you should choose the corresponding special cylinder.