How to correctly use the cylinder

A. Before using cylinder, screen cylinder without collision cause damage in transit, whether close connection parts, without exception to install and use. 2. The installation process, the cylinder piston rod can't afford to eccentric load can be transverse load, shall be the same axis direction of the load and the piston rod. 3. Either installation, must guarantee the cylinder body does not produce deformation, stiffness and the installed base of cylinder, we have to have a stable, are not allowed to load and the piston rod connected by electric welding welding. Four. Adjust speed: first, adjust speed control valve opening on the range of middle position, then gradually adjust the output pressure of pressure reducing valve, when the cylinder is close to scheduled speed, can determine the working pressure, and then use speed control valve for fine-tuning, finally adjust the buffer of cylinder, adjust the needle valve buffer so get absorption of inertia of the piston, the ultimate speed and does not impact cylinder head is advisable. Five. When mounted horizontally, cylinder, especially long stroke cylinder with level in the three o 'clock position ( The piston rod all stretched out, middle, and all return) Inspection. Six. Cylinder after the installation, should check the cylinder within the scope of work pressure, no load cases is working correctly, generally run two or three times. Seven. If used with adjustable buffer cylinder, before starting work, buffer valve should be tuned to damping the minimum position, after normal work of the cylinder, then slowly adjust buffer needle valve, increasing the buffer damping, until satisfied. Eight. The TA, TB, TC, CA, CB type installation type cylinder, had better add lubricating oil regularly combining site installation, to reduce the resistance and assure good mattress machinery cylinder operation