How to choose and buy cylinder?

Turn-back type parallel installations, the motor of electric cylinder and cylinder motor through the synchronous belt wheel with high strength are connected to the transmission of electric cylinder screw and drive the screw drive, besides has the characteristics of linear servo electric cylinder, and the overall length is short, less applicable to the installation location. Servo motor and electric cylinder with flexible, easy to install and set is simple, easy to use. Additional turn-back electric cylinder choose synchronous belt with high strength, small gap and long life characteristics such as the whole electric cylinder has high control and control precision. Right Angle type servo electric cylinder through the Angle of the motor type reducer or worm gear and worm reducer mechanism connected to drive screw, besides the advantages of linear and exhumation type electric cylinder, its total length is shorter, in the place of small space suit, can achieve big reduction ratio, small driving power, big thrust. So how to choose and buy cylinder, cylinder manufacturer for you summarize the following points. Electric cylinder can remain stable in the poor working environment, and realize high strength, high speed, high precision positioning, the smooth movement, low noise. So it can be widely used in papermaking industry, chemical industry, automobile industry, electronics industry, machinery automation industry, welding industry, etc. Servo electric cylinder work under complex environment only need regular grease injection, there is no need to maintain parts, replacement, reduces than hydraulic system and pneumatic system for a large number of after-sales service. Check cylinder standards adopted by the enterprise production, thus enterprise standard, should be compared with the industry standard. 3. Appearance, internal and external leakage of cylinder and no-load performance investigation: appearance: the surface of the cylinder cylinder and piston rod should be no scratches, end cover pore-free and trachoma. Internal and external leakage, in addition to the cylinder rod end there is no external leaks, internal leakage and out of the rod end leakage should be less than ( 3 + 0. 15 d) Ml/min and ( 3 + 0. 15 d) ml/min。 No-load performance: the cylinder is in the no load state, make its are in a low speed running, see what is the speed of its no creeping, the lower the speed, the better. 4. Pay attention to the installation of the cylinder form and size, the size of the installation in order to the manufacturer, cylinder, generally no spot, using standard as far as possible, so that we can shorten the time of delivery.