High temperature by adjusting the parameters of the pneumatic valve technology < / div >

high temperature regulating pneumatic valve under the condition of particularly high temperature, pneumatic valve pneumatic trims can choose stainless steel material, because there are many different kinds of stainless steel material, it also could be choice, according to the working condition of demand specific stainless steel high pressure regulating pneumatic valve has good high temperature strength ( General heat-resistant 450 ℃, can be customized special stainless steel and heat-resistant up to 1200 ℃) , when high temperature regulating pneumatic valve working at high temperatures, adjust the intensity of the pneumatic valve pneumatic valve body materials, hardness decreases with temperature rise, and should be considered when the use of the material temperature limit, if use temperature exceeds the limit, usually with better performance of heat-resistant material, but if some special condition, high temperature resistant regulating pneumatic valve pneumatic valve body still can not meet the requirements of heat-resistant stainless steel, would then add buy heat sink on the structure, pneumatic valve seat seal USES special material, conventional pneumatic valve body and trim materials is not applicable ( For example, o-ring, four fluorine material, elastic material and standard gasket, etc. ) 。
high temperature regulating pneumatic valve general stainless steel material is about 450 ℃, the highest temperature can be used for the occasion of higher than 450 ℃, usually adopt pneumatic valve body chrome - — Molybdenum steel for the maximum temperature of 1200 ℃ or so, usually choose SUS310S stainless steel, have different variety is an introduction, in short regulating pneumatic valve manufacturer can according to customer's requirements, working environment is selected for the user's high temperature regulating pneumatic valve.