Five kinds of special cases, trap processing method

Trap set to rise in parts of the occasion, under normal circumstances, the trap is installed below the position of the condensed water discharge device. But, if you want to install the trap condensed water discharge device, in the above must be installed in the front of the trap ascension joint, thus make the condensed water can be smoothly into the trap. The ascension joint ( 电梯配件) : can also be referred to as the suction connection. When condensed water discharge area is low, can pass it sucked to high and oriented in front of the condensed water. Export side return pipe, used for recovery of the discharge of condensed water trap pipe diameter should possess certain allowance, at least should be able to prevent the steam hammer or the effects of pressure loss. In addition, the collection tube with multiple pipes ( Return pipe) Connection, should be made certain inflow Angle, in order to facilitate the flow of the condensed water. Export side piping was flooded, the condensate to drain situations, if the drain directly into the water easy to cause the risk of condensation water splash. If must be flooded situation, in order to prevent the steam stops in upstream of the water in the drain to trap and fault occurs, shall be installed in the drain hole, or vacuum valve adjustment. Condensed water collecting device Settings, set the trap in the steam pipeline, condensed water collecting device needs to be designed. At the beginning of the ventilation and velocity faster occasions, it can effectively collect condensate, work better for steam trap. If there is no condensed water collecting device design, condensed water is not prone to discharge, garbage. Scale blockage phenomenon such as entrance. Different pressure condensed water recycling of pipelines, for condensate pipeline pressure conditions each are not identical, to design corresponding to each of the different pressure condensate recovery tubes, or install flash legs after recycling. Once the low pressure recovery tube into the high-pressure condensate, due to the condensed water temperature difference will be condensed water evaporation, again to produce noise. Steam hammer, etc.