Filter and pressure regulating pneumatic valve maintenance. 5)

routine maintenance, air filter and pressure control pneumatic valve ring virus is easy to be ignored. But often when the engine cylinder block and harm of their normal working hours, will not too as a maintenance replacement later. In order to avoid the engine ( Not normal) Premature wear and maintain the best working condition, the air cleaner and PCV pneumatic valve for regular inspection and replacement of pressure seems to be indispensable.
we emphasize the preventive maintenance of air filter is enough. Before filtered air inhaled air and fuel mixture, air filter dust, carbon and other impurities, so as to ensure the clean air suction. In fact, per unit volume of fuel combustion, than about the volume of air through the filter unit. Then a tiny dust particles can cause serious engine wear related internal parts.
usually, manufacturers recommend four hundred and eighty LingLingLingWan ten kilometers regular maintenance of air filter replacement cycle, each routine check two points four kilometers, take wengehua its conservative replacement cycle is advised to keep twenty-four thousand kilometers.
there are three different atmospheric density of the pollutants, the dust, debris and dust particles. In an open highway, less than rural, dust content in built up area. Dust larger area, air filter inspection and replacement frequency concentration should be higher. Highway and traffic congestion in the region, because of the vehicle emission concentration, the carbon content is higher in the air.
in routine oil changes, by the way, after all, check the air filter, a good habit to the best of both worlds. At this point, won the filters, look deep inside the fold carefully. Sometimes, external filter look clean, but inside is very dirty, this time must be replaced immediately.
ring system will leak into the air intake system mixture into the crankcase, and then in the second combustion chamber combustion. Over time, the oil, gasoline and other concentrated in the sludge into the circle of colloidal deposition pneumatic valve, pneumatic valve clogged PCV, thus improve the gas pressure inside the crankcase. Strengthen the pressure oil leak or gasket seal in more oil consumption and engine leakage fault, the cause of. In addition, increased through rings make viscous oil and air filter of automobil compounds of crankcase steam pressure, must reduce its filtering precision. When foreign body attached can't completely closed circle is not just the right amount of air to the introduction of the combustion chamber, diluting the air/fuel mixture, deteriorating, auto idle performance and easy to close.
manufacturers recommend the PCV pneumatic valve, normal maintenance replacement cycle is mostly 96 a. a. a. km; To maintain a conservative km replacement cycle. In any case, check the air filter at the same time, be sure to test pneumatic valve clogged PCV, and adhesive. Ford PCV pneumatic valve recommended replacement cycle is to rely on from. 吗? One thousand 〇万 six point zero km take different patterns, gm is in a different model, provides the corresponding PCV pneumatic valve replacement cycle suggestion, wider range of values. When you continue PCV pneumatic valve replacement cycle maintenance vehicles have any questions, please do not hesitate to get the user manual or maintenance information. This site keywords: pneumatic ball valve pneumatic ball valve pneumatic pneumatic valve pneumatic pneumatic valve pneumatic butterfly valve pneumatic butterfly valve pneumatic actuator