Feeding the use and maintenance of the pneumatic valve

(1) feeding pneumatic valve should be neatly stored in ventilated dry inside storeroom, forbidden piled up in the open air, or pneumatic valve size must use blind plug on both ends.
2. Before the installation must be carefully check the pneumatic valve, pneumatic valve and remove the internal damage caused by transportation, storage process.
(3) the screw force in when installation should pay attention to all balance, lift is flexible.
4. Feeding pneumatic valve should be installed where no violent vibration and impact, and the use of the site of the pneumatic valve without damage.
5. Discharge when getting blocked, you can use the metal rod or hard tools dredge, attention should be paid to the metal rod or hard tools don't damage the pneumatic disc and seal ring contact surface.
6 feeding pneumatic valve should try to avoid acid-base medium used interchangeably ( In addition to the neutralization reaction medium, so as not to shorten.
7) according to the dielectric performance and lifetime, often should check the feeding pneumatic valve top four fluorine pneumatic valve body sealing ring and orifice of four fluorine chips. If found damaged should be replaced in a timely manner to use again.