BURKERT one coil of pneumatic valve and what is the difference between double coil

BURKERT solenoid pneumatic valve main function is to control the water, at work, solenoid pneumatic valve opened, the water through tap water; At the time of downtime, closing solenoid pneumatic valve, cut off the tap water, so as not to waste water often flow. Water solenoid pneumatic valve ohm value is around. Can use the multimeter, measure its good or bad. BURKERT solenoid pneumatic valve can sometimes be activated carbon powder gets stuck, lead to closed lax, into the water, pure water and wastewater are small. Just open it, open static can be cleaning.

a few BURKERT solenoid pneumatic valve is pneumatic valve core has several working position, a few general is several import and export. Such as I now use more three four-way pneumatic valve, pneumatic valve core without power in the middle, on both sides of the two coil controlled pneumatic valve core to move to the left or right, the fact that three position name is three, three pneumatic valve spool is a import and export, more commonly used is a mouth without feeling when no electricity, coil electricity, through the movement of the pneumatic valve core, two and two are interlinked, realize the cycle of oil

BURKERT solenoid pneumatic valve does not work, can remove the solenoid pneumatic valve cup? Of course not. Because no cup is not safe. Water heater burning gas solenoid pneumatic valve is made up of water pressure to drive the micro switch power and action, solenoid pneumatic valve open, lighter at the same time. In addition the uneven pressure regulating pneumatic valve and pipe will affect the volume, which can lead to burning is not normal. Water pressure is too small the micro switch is not electricity, can adjust the reed switch, make its can plug under low water pressure, airway first checks by the uneven pressure regulating pneumatic valve, removing obstruction.

the fuel gas water heater solenoid pneumatic valve does not work first to see if the battery should be changed, if it is strong row may be a circuit board or electromagnetic pneumatic valve is broken, and if it is liquefied gas to see if pressure is too high, the water heater on trachea pull down if there is noise, electromagnetic pneumatic valve if there is air pressure is too high, it is ok to change a decompression pneumatic valve.

if the battery is installed, replace the battery is good, strong line plug is water heater igniter is broken, the water pressure is low, increase the clear booster pump inlet pipe, remove rubbish from nozzle solenoid pneumatic valve failure of ontology, replace solenoid pneumatic valve.