What are the general requirements regulating pneumatic valve group installed

（ ） Regulating pneumatic valve installation position should meet the requirements of process design, and should be near the related indicating instrument at a time, when used in bypass pneumatic valve manual for instrument can observe time;
　　（ ） Adjust the pneumatic valve should be arranged on the ground or platform and facilitate operation and maintenance;
　　（ ） Regulating pneumatic valve should stand vertical installed in horizontal pipe runs, under the special circumstances can be installed in horizontal or inclined, but must add support;
　　（ ） Adjust the pneumatic valve group ( Including regulating pneumatic valve, pneumatic valve, pneumatic valve and cut off the bypass drainage pneumatic valve) Facade when installation, adjustment of the pneumatic valve should be installed in the bypass below. The adjustment of the nominal diameter less than mm pneumatic valve, also can be installed above the by-pass;
　　（ ） Adjust the bottom of the pneumatic valve is apart from the ground or on the surface of the platform clearance should not be less than the mm. For the loading of single and double regulating pneumatic valve, pneumatic valve core should be set aside to smoke at the bottom of the pneumatic valve pneumatic valve core space;
　　（ ） Regulating pneumatic valve film on the clearance should not be less than the mm above. Adjust the pneumatic valve and bypass valve and the layout should be measures open position;
　　（ ） Cut off the pneumatic valve, pneumatic valve should choose gate by-pass pneumatic valve should be chosen by the pneumatic valve, but the bypass pneumatic valve nominal diameter greater than the mm, can choose pneumatic valve gate, two cut pneumatic valve and regulating pneumatic valve arrangement straight into a straight line;
　　（ ） In regulating pneumatic valve inlet side and cut off the pneumatic valve upstream of the pneumatic valve should be set drainage pipe low between the pneumatic valve, pneumatic valve drainage optional pneumatic valve gate.
　　（ ） Medium containing solid particles of the regulation on the pipeline pneumatic valve with by-pass pneumatic valve arranged in the same plane or will bypass regulation pneumatic valve arranged on the bottom of the pneumatic valve;
　　（ ） The regulation on the low temperature, high temperature pipe pneumatic valve group should be one of two stents is fixed bracket, the other one is the sliding bracket;
　　（ ） Regulating pneumatic valve should be installed in the environment temperature is not higher than ℃, no less than. . . ℃, and away from the vibration source;
　　（ ） On an area that contains more regulating pneumatic valve group, should consider to form consistent, neat, beautiful and easy to operate;
　　（ ） Adjusting the diameter of the pneumatic valve pneumatic valve and partition is not at the same time, reducing pipe shall be installed near the adjustment between;
　　（ ） Pay attention to the process of regulating pneumatic valve position without special requirements.

regulating pneumatic valve manufacturers recommendation: yongjia jingwei pump pneumatic valve co. , LTD. Thick pu pneumatic valve co. , LTD