Submerged electromagnetic pulse pneumatic valve possible fault 3

may be submerged electromagnetic pulse pneumatic valve failure:
submerged electromagnetic pulse pneumatic valve breakdown and possible ways of
. Running resistance
the reason may be: gas short circuit, damage to the luggage, pressure measuring device or main induced draft fan current meter failures;
the way rules: at this point in the visible light emission inspection and repair welding concentration increased, check and change the bag, change or repair the fan.
。 Running resistance big
may be due to: condensation paste bag, electromagnetic pulse pneumatic valve does not work, or damage, the pressure is too low, submerged electromagnetic pulse pneumatic valve pneumatic valve core shut is lax work, one or more of the pneumatic valve closed position.
eliminate methods: blocking progress of air leakage of flue gas temperature, increased ventilation, the work done by the filters and the pipeline heat preservation; Protection or exchange of submerged electromagnetic pulse pneumatic valve, check the gas and air compressor; One-way pneumatic valve and control device to promote clean.
。 Submerged electromagnetic pulse pneumatic valve does not work, may be due to:
clean power outage or failure to grasp; There have been sundry electromagnetic pulse pneumatic valve, leakage; Submerged electromagnetic pulse pneumatic valve coil burn out; Compressed air pressure is too low. Excluded methods: recovery or repair power electromagnetic pulse pneumatic valve control device seriously liquidate liquidation; Replace the electromagnetic pulse pneumatic valve coil, check air conditioning system and compressor.
。 Package repair or replacement:
in normal circumstances, the application period gradually destroyed the bag, it is important, because the dust is grinding, high temperature, high humidity caused deterioration of the media. Cannot use filter filter bag broken work, otherwise the consequences will affect the dust. When the new filter bag replacement, shall be on the basis of the performance of the fourth test, increase the resistance, so that resistance is close to polish.
。 Upgrade may be due to the pneumatic valve does not work:
clean power or control failure, cylinder damage or card dead, cylinder electromagnetic solenoid coil burn, cylinder solenoid pneumatic valve, dirty jams or pneumatic valve core dry mouth ventilation, activity can't. The compressed air pressure is too low, six security is a famous old revolutionary base areas;
eliminate: recovery or repair the cleanness of electric control device; Carefully check, clean and repair the cylinder; Ac electromagnetic solenoid coil, check the gas system and a tightening machine. This site keywords: pneumatic ball valve pneumatic ball valve pneumatic pneumatic valve pneumatic pneumatic valve