Steam solenoid pneumatic valve installation note 10 items

, before install solenoid pneumatic valve, pipe must be clean. Installation of the filter in front of the pneumatic valve is recommended, hydrophobic pneumatic valve steam pipeline installation.

, in the pipeline system, installed on the branch of the solenoid pneumatic valve size should be less than the main sizes of pneumatic valve.

failure occurs, the electromagnetic pneumatic valve, in order to timely isolation solenoid pneumatic valve, and ensure the normal operation of the system, the best install bypass devices

the working medium of pneumatic valve, electromagnetic should be clean and no impurity particles, electromagnetic pneumatic trims on the surface of the dirt and filters, need to clean on a regular basis.

, when installation, electromagnetic solenoid coil up, and keep the vertical position, the arrow or mark in the solenoid pneumatic valve should be consistent with the pipe flow, shall not be installed in places with splashing water or water leakage.

and pneumatic valve can not be installed in the pipeline of dips, lest because of steam condensation water, impurities, such as the precipitation in the pneumatic valve and hamper the action.

and cannot be used in explosion hazard.

, under the condition of insufficient rigidity pipeline, recommend to use before the pneumatic valve pipe bracket, so as to avoid electromagnetic vibration caused by pneumatic valve work.

and before installation, pay attention to see the product sign, read the instruction for use, to determine whether a product conforms to the conditions of use.

pneumatic valve should be installed in the pipeline before and after the pressure gauge, electromagnetic, in order to observe the pipe pressure.