Stainless steel pump maintenance

（ ） Check the water pump and pipeline, no loose and the junction of stainless steel. Rotating stainless steel pumps, stainless steel pump test are flexible. A ( ) Added to the bearing lubrication bearing body, observe the oil level should be the main body of the center line of the oil, lubricating oil should be timely replacement or supplement. （ ) Remove the plug pump stainless steel pump, water filling ( Lead or cream. ) （ ) Shut out of the water pipe pneumatic valve, import and export pressure gauge vacuum gauge. （ ) Mobile motor, motor rotation, proved to be correct. （ ) Start the motor, when the normal operation of the water of the stainless steel pump, open the outlet pressure gauge and import vacuum pumps, depending on the display the appropriate pressure, gradually open the pneumatic valve, and check the motor load. （ ) Control flow and as far as possible, within the scope of the stainless steel pan head counter on the pump to ensure the operation to the highest efficiency point stainless steel pump, to achieve maximum energy saving effect. （ ） Stainless steel pump working process, the bearing temperature is no more than the environment temperature, the highest temperature shall not exceed the degrees Celsius. （ ） Found unusual stainless steel pump, should immediately stop, and check for good reason. （ ） Stainless steel pump stop using, close the pneumatic valve, pressure gauge, then stop the motor. （ ) Stainless steel in the work, the oil change hours, after the first month of the pump, every hour, oil change at a time. （ ) Often adjust the packing gland, packing room, in order to ensure that the normal water ( Such as the appropriate drop out. ） （ ） Check the wear of shaft sleeve, more should be replaced after being worn out. （ ） Stainless steel pump in winter use, parking, plug unscrew the media need to pump the lower part of the net. In order to prevent cracking. （ ） Stainless steel water pump stop for a long time, all need to pump, dry water, and in the proper storage and installation grease coating in the moving parts.