Stainless steel ball of the pneumatic valve installation details

stainless steel ball pneumatic valve when installation should be strictly carried out in accordance with the installation requirements on the product manual, here are stainless steel ball pneumatic valve when installation should pay attention to the details to do the following:
. Under the conditions of stainless steel ball pneumatic valve fully open to rinse;
　　. Stainless steel ball after pneumatic valve and pipeline connection, shall use the prescribed torque cross locking flange bolts;
　　. In stainless steel flanged ball before connected to the pipe, pneumatic valve must be clean pipeline residual impurities;
　　. During the installation, part of the pneumatic valve actuator with a ball as a lifting of the lifting point, to avoid damaging actuators and accessories;
　　. Cast steel flange ball pneumatic valve should be installed in horizontal or vertical direction;
　　. Cast steel ball near pneumatic valve installation of pipe cannot endure with low or the phenomenon of external force, can use a pipe support or support to eliminate line deviation;
　　. Install the stainless steel ball pneumatic valve shall be in accordance with the provisions of signal should be on the test, after qualified to install.