Solenoid valve is not action any troubleshooting method at low temperature

Low electromagnetic valve does not action any troubleshooting methods a loose, import solenoid valve terminal at low temperature or falls off thrum, electromagnetic valve shall not electricity, can tighten thread ends. Second, the import solenoid coil burn out, can remove the solenoid valve connection, measured with a multimeter, if open circuit, the electromagnetic valve coil burn out. Coil be affected with damp be affected with damp, reasons caused bad insulation and magnetic flux leakage, causing excessive current in coil and burned down, so to prevent rain water from entering the solenoid valve. In addition, the spring quality, reaction force is too large, the coil number of turns is too little, not enough suction also coil may be destroyed. When emergency treatment, but the manual button on the coil by the normal work of '' hit' ', makes the valve to open. Third, jam solenoid valve solenoid valve valve and valve core set of fit clearance is small ( Less than, mm) , are generally single assembly, when mechanical impurities into or lubricating oil is too little, it is easy to get stuck. Treatment methods available wire holes stab, from the head to make it back. The fundamental solution is to solenoid valve will be removed, remove the valve core and valve core, clean with CCI, makes the valve core within the valve sleeve flexible motion. Removal should be paid attention to when all parts, assembly sequence and wiring position to reassemble and wiring is correct, also check oil mist detector injection hole blockage, lubricating oil is enough. Four, leak air leakage will cause the air pressure is insufficient, make it easier for mandatory valve opening and closing, the reason is that sealing gasket damage or slide valve wear several cavity caused by gas. Electromagnetic valve throughout the hour ordering hotline more see HTTP / / all kinds of electromagnetic valve products