Shandong cylinder in the design have any requirements

Shandong cylinder is when the design requirements of the cylinder type are many, but whatever the cylinder, on the basis of the principle of design is a certain request, because both metallurgical cylinder and to design the tie rod cylinder block are very cautious. First the principle of cylinder according to the size of the work force needed to determine the thrust and tension on the piston rod. In order to select the output force should make the cylinder when the cylinder is slightly allowance. If picked the small cylinder diameter, the output power is not enough, the cylinder does not work; But the diameter is too large, the device not only heavy, high cost and the gas consumption increases at the same time, cause energy waste. In fixture design, should as far as possible the power mechanism, in order to reduce the size of the cylinder. Moreover the design requirements of shandong cylinder cylinder is a piston compressor in the main part of the volume of compressor. According to the pressure, to achieve by displacement compressors, compressor structure scheme, the kinds of compressed gas, making the cylinder material as well as the habit of factory conditions, the structure of the cylinder can take many forms, design of cylinder main requirements are as follows: as much as possible, reduce the clearance volume inside the cylinder and the gas resistance; , combined with the part of the connection and sealing is reliable, have good manufacturing process performance and easy to tear open outfit; , cylinder diameter and seat mounting holes size should comply with the requirements of 'three'. Should have sufficient strength and rigidity, and cylinder working surface has good wear resistance; Work, want to have a good cooling, the surface should have good lubrication condition. So in the design, do not give attention to ignore, it is very important! Hope the above is helpful for you.