SC standard cylinder knowledge points

SC standard cylinder is suitable for use in a variety of different industries, specially used in dust removing device. This cylinder is usually configured with ascending valve and electromagnetic pulse valve used together. Produce factory can according to customer's detailed requirement and the actual need to design different diameter, flange, as well as the different stroke cylinder, cylinder cylinder configuration parts single ear ear, as well as the standard of gas cylinder rod and extended gas cylinder rod, etc. Structural characteristics, SC standard cylinder end cover USES a new type of pressure casting processing technology. Use, cylinder is of high quality aluminum alloy material drawn tube road, internal surface by Yang level rigid oxidation processing and manufacturing. , the cylinder piston rod surface utilization is rolling in advance hardening processing technology, through the hard chromium electroplating, fine grinding, have excellent to prevent rust, wear-resisting, etc. , above the SC standard cylinder airtight structure is novel, quality is excellent, able to provide lubrication oil under the condition of without there is no abnormal operation, less pressure cylinder initial start-up time, prolong its service life. , cylinder end cover both before and after carrying the standby aerate screw, convenient for users to install location selection. Installation and use, the work load have change, should choose the output force abundant cylinder, under the condition of high temperature, should choose corresponding high-temperature cylinder. Before, cylinder pipe, must be removed tube sundry, to prevent the cylinder from the ingress of debris. , cylinder using medium should go through & amp; mu； M above filter filter rear can use. , in low temperature environment, antifreezing measures should be taken to prevent water frozen in system clean. , cylinder before use should be the no-load test run, before running buffer to a minimum, enlarge gradually, lest produce big shock and loss of cylinder. Cylinder should avoid as far as possible in the process of work, lateral load, in order to maintain the service life of the normal work of the cylinder. , the cylinder to be removed for a long time not to use, must pay attention to the surface rust, should add dustproof plug into the vent cap.