SC cylinder using the matters needing attention

SC cylinder using note SC cylinder work load have change, should choose the output force abundant cylinder; Under the condition of high temperature or corrosion, should choose the appropriate resistance to high temperature or corrosion of the cylinder; In high humidity, dust, or drops of water, oil, dust, welding slag, cylinder corresponding protection measures should be adopted; Cylinder connected to the pipe before, it is necessary to clean the dirt in the pipe, prevent the cylinder from the ingress of debris. According to the size of the work force needed to determine the thrust and tension on the piston rod. In order to select the output force should make the cylinder when the cylinder is slightly allowance. If picked the small cylinder diameter, the output power is not enough, the cylinder does not work; But the diameter is too large, the device not only heavy, high cost and the gas consumption increases at the same time, cause energy waste. In fixture design, should as far as possible the power mechanism, in order to reduce the size of the cylinder. SC cylinder should be subject to um above price quality filter filter rear can use. Cylinder in the process of work by lateral load should not exceed allowable values, in order to maintain the normal operation and service life of cylinder; Antifreezing measures should be taken in low temperature environment, to prevent the water freezing in system; Cylinder to be removed for a long time need not, should pay attention to the surface rust, should add dustproof plug into the vent cap, due to the high precision products production and guide, please do not remove the cylinder fixed block or cylinder head on its own.