Military electromagnetic valve in the hot melt glue gun with the application of technology

Military electromagnetic valve in the application of hot melt glue gun technology marketing time military electromagnetic valve on the working principle of the gun gun the gas-off or air spring close, built-in filter, prevent impurities obstruction. Can take multiple nozzle, the piston rod used to open the closed glue, glue quantity related to pressure, nozzle aperture size, the adjusting nut can adjust the amount of glue. Use removable heater, heating air, built-in flame state and control circuits, nozzle piston pneumatic drive is controlled by the solenoid valve, rubber in order to realize the opening and closing of the road. Gun installation. Storage and transport spray gun using collision materials packaging, carton transport, can be mixed with other components. Maintenance requirements spray gun power and temperature control line provided by the throat built-in wire, plug connector for military aviation; Working gas is controlled by A solenoid valve, solenoid valve should be paid attention to cleaning and lubrication, electromagnetic valve as four-way solenoid valve, interface for/inch screw, export is expressed as A ( Export) B ( Export declaration) 。 。 Installation instructions through before delivery has been test of gun, can immediately installation operation, each gun can have a gas solenoid valve control, due to the spray gun switch speed, solenoid valve control should be consistent as far as possible close to the spray gun and keep their distance. Spray gun can be installed on the host, you need spray gun body frame size for installation. Mm diameter of mounting holes, with mm screw tightening. Spray gun body with filter device and spray adhesive quantity trimming function, observation of middle hole nozzle can check nozzle working condition and seal are in good condition, and the general application should not exceed nozzle and surfaces. mm( / inch) 。 Spray gun connected to the throat spray gun connected with two sets of wrench on the throat ( Optional °, °, ° joint) 。 Connect the spray gun electrical connector on the pipes, electrical connectors. Connect the four-way solenoid valve and spray gun electric road, when need to spray gun shut, compressed air from the electromagnetic valve to port B, when the solenoid valve action of compressed air to port A, open spray gun, air pressure kg/cm2. Check the temperature of the spray gun can be read by the host temperature, spray gun available surface temperature thermometer shall be checked. Spray gun and air in applying, heat gun, unscrewing the nozzle, the container below, solenoid valve open gear pump, air and oil gun to discharge until spewing for hot melt adhesive. Will be loaded on the nozzle, spraying hot melt adhesive, inspection are in good condition. Four. Active gas bomb huang close design, reaction velocity sensitive and reliable. The built-in filter, can reduce the fault caused by jam coated mouth. Nozzle is made of imported wear resistant material, after special craft processing, durable, use for a long time not wear. Germany's latest sealing structure components, ensure that gun running stable and durable. To low or high speed intermittent and continuous spray adhesive work and can even put the coating on the coating, the glue gun effect in block.