Introduction to the use of pneumatic components of cylinder

Cylinder and pneumatic components of the important component, to make sure that the cylinder is in use process can work normally, prevent unnecessary condition, today we are here to discuss the use of pneumatic components of the cylinder. When using cylinder, very tall to the requirement of air quality, clean and dry compressed air is used, the air must not contain any organic solvent of synthetic oil, salt, and corrosive gas, etc. , to prevent bad cylinder, valve action. Before the installation, should be fully connected with tube blow wash, do not use dust, impurities such as pieces of scraps, at the end of the sealing strip into the cylinder valve. In the dust, water, the oil droplets, rod side should take telescopic protective cover, installation, do not twist twist state. Cannot use the occasion of telescopic protective sleeve, should choose waterproof with powerful shield cylinder or cylinder. Standard cylinder shall not be used for the corrosion of the fog or swelling in the sealing ring of the fog. For oil lubrication cylinder shall be equipped with reasonable flow of oil mist, not to give oil cylinder for pre added grease in cylinder, you can use for a long time. This cylinder can also be used for oil, but once the oil is not stop to the oil, because additive could have been washed away grease, do not give bad oil will lead to a cylinder. Cylinder at the end of the installation site to prevent drilling chip from the cylinder into the intake. A laparoscope, usually connected to a cylinder cannot be used as a gas liquid cylinders, in case of oil spill. Cylinder and piston rod of the sliding parts shall not be damaged, in order to prevent damage of cylinder, piston rod sealing ring etc cause air leakage. Cushion valve adjustment maintenance should be set aside space, magnetic switch, etc should be set aside the appropriate space to install. If the cylinder is not in use for a long time, we should move once a month, and oil to protect to prevent rust.