Injection molding machine electromagnetic valve installation considerations

Injection solenoid valve solenoid valve installation considerations network small day time class components installation type pipe, plate, the superposition type and embedded as a variety of types, different type, installation method and requirements are also don't ask. Superposition type integration was make electromagnetic valve body is a standard size feed square, will be used when using components present plate pile, and then use rod close by, its characteristic is, fundamentally eliminate the connecting line between the electromagnetic valve and solenoid valve, so the system of worshiping more single, concentrated, compact, flexible assembly system, is advantageous for the oil to improve. Injection molding machine electromagnetic valve hydraulic components installation method and requirements are detailed in the product manual. Components in the factory has been pass quality inspection and performance test, with a plastic plug the oil outlet to block. Spare parts are attached to a certain number of seal in the inner packing plastic bags. Before use, should check whether the certificate of quality, instructions and spare parts are complete, and check for packing, damage, or a foreign body, oil mouth open. Before the installation with kerosene. When installation should also pay attention to the oil mouth don't wrong, General components of each oil mouth have text or code mark) ; To maneuver control electromagnetic valve is installed, must pay attention to the CAM and block of the itinerary and the distance between the electromagnetic valve, in order to avoid crash test run; With flange installation components, connecting screw to screw is appropriate, twist too tight even sealed; Some network class has opened a hole for easy manufacture and installation, after installation shall be rendered unnecessary avenues. After installation, all kinds of components spare seal trap should keep, in case of using changed during maintenance. When installing hydraulic solenoid valve must also pay attention to the following points, before the installation, hydraulic solenoid valve for opening the inspection certificate of quality and review the instructions carefully, and when it is necessary to check yan pressure and sealing. , figure out the oil inlet electromagnetic valve and oil bearing. , electromagnetic valve installation position without special provisions, shall be installed in the position of ease of use, maintenance. Direction control yan installation level shall be maintained. , with flange installation of solenoid valve, screw cannot twist too tight, so as not to cause bad sealing. , certain electromagnetic valves are open hole for easy manufacture and installation, after installation, useless holes shall be closed. , some of the solenoid valve installation time purchase, allows for through traffic over the rated flow for % of the hydraulic solenoid valve substitute.