GSR solenoid pneumatic valve failure and troubleshooting steps

and loose header or thrum off solenoid pneumatic valve, electromagnetic pneumatic valve can not electricity, can tighten thread ends.
pneumatic valve, electromagnetic coil burn out, can remove the solenoid pneumatic valve set, measured with a multimeter, then open circuit, the pneumatic electromagnetic valve coil burn out. Cause a cold coil, resulting in poor insulation and magnetic flux leakage, cause excessive direct current in coil and burned down, and thus to prevent water into the solenoid pneumatic valve. In addition, spring quality, too hard, coil number of turns is too little, not enough suction can also make the coil burned down. When amazing solution, but the manual button on the coil by the abnormal operations of '' hit ', make the pneumatic valve is opened.
pneumatic valve, electromagnetic stuck. Slide of pneumatic valve pneumatic valve and pneumatic valve core set of fit clearance is small ( Less than. Mm, normal are piece removed, when there is a mechanical impurities into smooth oil or too little, get stuck very easily. Solution procedures available wire holes stab, from the head to make it back. Basic steps to overcome is to solenoid pneumatic valve will be removed and deposited in the pneumatic valve core and pneumatic valve core sleeve, with CCI cleansed, makes the pneumatic valve core moves sensitive in pneumatic valve set. Assembly of each component should be careful when remove the flashbacks and internal reports, not from the new disassembly and notified errors, but also examine whether oil mist device injection hole block, smooth whether the residual oil.
and breathable. Air can cause atmospheric pressure, make mandatory pneumatic valve opening and closing, the cause of sealing gasket is corrupt or slippery pneumatic valve wear how many cavity gas.
in solving the fragmentary solenoid pneumatic valve switch failure, should choose the appropriate opportunities, such as the electromagnetic pneumatic valve lies in the loss of power to continue the solution, if not solve down in a switch gap, switching pieces can be suspended, in no hurry to solve.