Explosion-proof solenoid valve installation steps

Explosion-proof solenoid valve installation steps of China's environmental protection equipment exhibition network liang zhang, install solenoid coil up, and keep the vertical position, the arrow or mark in the solenoid valve should be consistent with the pipe flow, shall not be installed in places with splashing water or water leakage. Working medium, the electromagnetic valve should be clean and no impurity particles, electromagnetic trims on the surface of the dirt and filters, need to clean on a regular basis. , the electromagnetic valve failure occurs, in order to timely isolation solenoid valve, and ensure the normal operation of the system, the best install bypass device, in the pipeline system, installed on the branch of the solenoid valve size should be less than the main valve. Before, install solenoid valve, pipe must be clean. The installation of the filter in front of the valve is recommended, steam pipe installation steam trap. , can't install the valve in the pipeline dips, lest because of steam condensation water, such as precipitation of impurities in the valve and prevent action. And cannot be used in explosion hazard. , under the condition of insufficient rigidity pipeline, recommend to use before the valve pipe bracket, so as to avoid electromagnetic valve caused by vibration while working. , before the installation, pay attention to see the product sign, read the instruction for use, to determine whether a product conforms to the conditions of use. , electromagnetic valve should be installed on the pipeline before and after the pressure gauge, in order to observe the pipe pressure. The above points is explosion-proof solenoid valve installation steps.