lv-pneumatic
Pneumatic industry,Diaphragm Valves of Bag House Filter, Personalized Customization
Electric valve need to know some maintenance methods
by：AIRWOLF
2021-01-20
Enterprise in the use of electric valve, the need to know some maintenance methods!
. Electric valve body to assembly bolts must be symmetrical, step by step, to tighten evenly.
. Non-metallic parts after cleaning shall be immediately removed from cleaner, may soak for a long time.
. Only before and after unloading valve pressure, can to dismantling the valve operation.
. After wash wall detergent volatilization and after cleaning, Available not soak cleaner silk cloth to wipe) Are assembled, but shall not be shelved for a long time, or it will rust and dust pollution.
. In the valve decomposition and assembly process again, need to have the protection of the sealing parts, especially non-metal components, parts like o-rings it is best to use special tools.
. Break down the single parts can use dip way to clean. Still left did not break down the non-metallic metal parts can be fine clean clean immersion cleaner silk ( In order to avoid fall off fiber adhesion on the parts) Scrub. When cleaning should remove all adhesion on the surface of grease, dirt, plastic product, dust, etc.
. Electric valve assembly time should not be allowed to have metal chips, fiber, fat ( With the provisions of the exception) Dust and other impurities, foreign bodies, such as pollution, adhesion, or stay on the parts surface or into the lumen.
. Electric valve body to assembly bolts must be symmetrical, step by step, to tighten evenly.
. Non-metallic parts after cleaning shall be immediately removed from cleaner, may soak for a long time.
. Only before and after unloading valve pressure, can to dismantling the valve operation.
. After wash wall detergent volatilization and after cleaning, Available not soak cleaner silk cloth to wipe) Are assembled, but shall not be shelved for a long time, or it will rust and dust pollution.
. In the valve decomposition and assembly process again, need to have the protection of the sealing parts, especially non-metal components, parts like o-rings it is best to use special tools.
. Break down the single parts can use dip way to clean. Still left did not break down the non-metallic metal parts can be fine clean clean immersion cleaner silk ( In order to avoid fall off fiber adhesion on the parts) Scrub. When cleaning should remove all adhesion on the surface of grease, dirt, plastic product, dust, etc.
. Electric valve assembly time should not be allowed to have metal chips, fiber, fat ( With the provisions of the exception) Dust and other impurities, foreign bodies, such as pollution, adhesion, or stay on the parts surface or into the lumen.
Custom message
