Electric pneumatic valve controller installation and adjustment

electropneumatic valve controller of installation and adjustment:
, according to the specifications of choose and buy according to the figure to fix its installation, earthing terminal on the rear panel must be reliable grounding.
and the circuit diagram of controller and the electric actuator is the same, with a cable in the same terminal, connect the controller and electric devices, if the user does not need on-site control,,,, terminal is not answered. Electric pneumatic valve controller used in the automatic control system,,,, terminal used in 'automatic', 'auto off' the corresponding signal input terminals.
, press the power button, the power indicator, the remote control switch to remote control, remote control indicator.
pneumatic valve opens, use the handwheel to % opening, press the pneumatic valve open or close the pneumatic valve, pneumatic valve check whether the handedness and press the button of a
, such as inconsistent press stop immediately, to cut off the three-phase power supply, change the three-phase power supply any of the two phase.
, press the pneumatic valve, pneumatic valve fully open in place, when open the pneumatic valve indicator light on the front panel. Press where the pneumatic valve, pneumatic valve is fitted in place when
when close the pneumatic valve indicator light on the front panel; When the pneumatic valves in the process of opening or closing needs to stop, press the stop key, pneumatic valve to stop.
the number and the terminal sub, the incident light on the front panel.
and when the pneumatic valve is in full open position, adjust potentiometer on the front panel, to make the opening table shows %.
and the remote control switch to the scene, the scene indicator, short circuit, and, terminals, pneumatic valve and open to run, for point move
state; Short circuit and terminal, pneumatic valve to close to run, to dynamic state.
and insurance tube on the rear panel, A.