Cylinder type and some parameters of the difference between questions

Cylinder, it is a very common and common, mainly because of its wide application, so, in some areas, is can often see the figure of it. And, on the site, also is the important and main product, so the integrated these factors above, the learning and understanding, is inevitable, and not a little careless, in order to avoid cannot get good learning effect, allow yourself to do more harm than good. 。 Ordinary cylinder, its usually have which a few place? And, if it can through the magnetic switch, to stop a particular position? Also, cylinder diameter, it can be equated to what? On ordinary cylinder, usually have two locations, one is out of position, the other is a retracted position. If, the use of magnetic switch, then, is not to stop to a specific location on the cylinder. So, to question 2, the answer is no. As for the cylinder bore, it is equivalent to the cylinder bore. 。 Pull and push the cylinder piston rod, should according to what? Pull and push the cylinder piston rod, mainly according to the size of the work force needed to determine. And also know that, in the selection work of cylinder, for its output force, want to have a certain margin, because, bore is not appropriate, then, be a problem. 。 Single-acting and double-acting cylinder, as well as single action and double acting cylinder, the main difference between them, what is it? Single-acting and double-acting cylinder, the primary difference between the two, is is that the single-acting cylinder, its only one pressure holes, but there is spring, and double-acting cylinder, it is not spring, but there are two pressure holes. Single action and double acting cylinder, the primary difference between them, is that only a single action cylinder mouth trachea, and double acting cylinder, there are two mouth trachea. To know and understand about cylinder, it can be said that these, is very basic and important, and we all right and the theoretical basis for the rational use of cylinder, therefore, should be taken seriously is, in this way, the ability to master in time, and use very good luck in the actual work, make learning a certain value and significance.