Cylinder parts structure principle is introduced

Cylinder parts structure principle of the cylinder is one of the components is commonly used in pneumatic components, the understanding of the principle of structure of different parts of cylinder, is conducive to the maintenance of cylinder, flywolf pneumatic for everybody below brief introduction: cylinder main parts such as cylinder, cylinder head, piston and piston rod. These parts are the most important parts in the cylinder, are respectively introduced their structure and so on are as follows: structure depends on the cylinder head, cylinder even the league form factors, such as its structure usually has two kinds of flange and straight. , connected structure depends on the cylinder head and cylinder form, dust seal form, the presence of buffer device and manufacturing method and other factors. No buffer cylinder in order to increase the piston air inlet area, reduce the piston start time, quickly drive piston movement, needs to increase at least in cylinder head mm deep sink hole, the hole must be with air inlet. The structure of buffer cylinder buffer device should be considered; Cylinder head, besides considering seal, still need to pay attention to the dust, in order to avoid too much dust and other impurities into the cylinder, affecting the service life of cylinder. Depends on the form and guide ring seal, piston structure and other factors. The number of its width with the sealing ring and guide ring form and so on. Cylinder with switch magnetic should also be considered the installation position, the piston to make two postures. And the piston rod is one of the most important mechanical parts in the cylinder, the structure has two kinds of solid and hollow. The hollow structure of the piston rod is suitable for:) Need through the center of the piston rod clamping bar, clamping workpieces and other devices, etc. ) In order to increase the stiffness of the piston rod and lose weight. ) Fixed piston rod, cylinder for reciprocating motion, the inner hole of the piston rod.