Cylinder common faults how to solve

And cylinder buffer effect is bad, is usually due to buffer sealing ring damage caused by wear or the adjustable screw. At this time, should replace the sealing ring and adjusting screw. Internal and external leakage, cylinder appeared, usually because of the piston rod installation eccentric, lubricating oil supply, seals and sealing ring, wear or damage to the cylinder contains impurities and piston rod has a scar, etc. So, when there is internal and external leakage of cylinder, should readjust the center of the piston rod, to ensure the alignment of the piston rod and cylinder; Must often check whether oil mist detector work reliable, to ensure good lubrication performance of the actuators; When the sealing ring and sealing ring ring wear or damage, should change in time; If there are impurities in the air cylinder, should keep clear of in time; When there is scar on the piston rod, should change new. , cylinder, piston rod and cylinder head is damaged, usually because of the piston rod installation eccentric or buffer mechanism doesn't work. To this, should be adjusted to the center of the piston rod; Replace the buffer ring or adjusting screw. Did not have enough power, the output of the cylinder and the movement is not smooth, usually because of piston and piston rod stuck, poor lubrication, expanding supply shortage, or cylinder with condensed water and impurities, etc. To this, the center of the piston rod should be adjusted; Check of oil mist and reliable; Gas supply pipe is blocked. When the cylinder is memory is condensed water and impurities, should keep clear of in time.