Aluminium alloy pipe pneumatic valve structure characteristics and working principle
by:AIRWOLF2021-01-16
aluminum alloy pipe clamp pneumatic valve structure features: aluminum alloy tube clip clip pipe pneumatic valve pneumatic valve also known as aluminum alloy, aluminum alloy hose, pneumatic valve, pneumatic valve from about aluminum, rubber hose, pneumatic valve stem, upper and lower ram size, guide pillar and other parts.
Wear-resisting, anti-corrosive, frost resistance, good seal performance, simply replace glue set is in good condition, such as new, pneumatic valve can be used forever, life is ordinary pneumatic - valve
Times.
Drive way has a manual, pneumatic, electric and so on a variety of ways, can also be customized according to customer demand non-standard products.
aluminum alloy pipe clamp working principle of the pneumatic valve: when shun changed hands round, make the size of pneumatic valve rod drives the ram up and down at the same time, the compression tube set, were closed, inversion is open, so, ram up and down reciprocating between guide pin to complete the pneumatic valves open and close work.
In addition, because of the rubber sleeve bearing, so when the switch, the operator rotate handwheel as long as was moderate, open and close has achieved pole, do not try to or more auxiliary, open and close to disable the other tools.
aluminum alloy pipe clamp pneumatic valve scope of application: chemical, petroleum, electricity generation, alkali factory, mineral processing, cement, coal, nonmetal industries, quick sand control pipe concentration of granular flow with the globe.
aluminum alloy pipe clamp pneumatic valve main technical parameters: and use the medium: pulp, waste water, slag, coal cinder, sediment, etc.
, suitable temperature: -
-
Custom separately, the higher temperature.
, nominal pressure: -
。
- - - - - -
。
Mpa(
An order.
, flange standards: (
JB / -
。
main shape aluminum alloy pipe clamp pneumatic valve connection size: